download 1. Hood a. Place the vehicle in Park with the Parking Brake set.
b. Remove the Rear Board. c. Remove the Rear Box. d. Remove the Rear
Trims to gain access to the Battery. e. Disconnect the Negative Battery
Terminal. • Note the Battery Cable Position as it will be re-installed
in the same position. CAUTION: Do not touch Positive Terminal. f.
Swap the Bolt and Nut on the Negative Battery Terminal from one side to
the other for easier installation. WITH Hood Switch (Go to Next
Section, Page 10) WITHOUT Hood Switch Fig. 1-5 Vehicles Without
Hood Switch ONLY g. Dislodge the Radiator Hose to gain access
to the Hood Latch Assembly. Fig. 1-7 EXAMPLE Make sure to hold the
Hood Switch by its sides. Make sure the Hood Switch Lever is positioned
properly. If the Hood Switch is Broken RES will not function.
Fig. 1-8 i. Install the Hood Switch with the Switch Lever
underneath the Hood Latch Trigger Lever. CAUTION: Make sure the Hood
Switch Lever is under the Latch Lever. j. Tighten 1 Screw. k. Connect
the Vehicle’s Hood Switch Connector to V4 Hood Switch Connector.
Disconnect the Jumper Connector if installed. l. Reinstall the Hood
Latch Assembly. m. Torque the Hood Latch Bolts to 66.4 in•lbf (7.5
N•m). h. Dislodge the Hood Latch Assembly. • Remove 3 Bolts. Make sure
to hold the Hood Switch by its sides. Make sure the Hood Switch Lever
is positioned properly. If the Hood Switch is Broken RES will not
function. i. Install the Hood Switch with the Switch Lever underneath
the Hood Latch Trigger Lever. CAUTION: Make sure the Hood Switch Lever
is under the Latch Lever. TVIP V4 REMOTE ENGINE STARTER (RES) n.
Secure the Vehicle Hood Switch Harness to the Vehicle with 1 Wire Tie.