download Preparations: (Dismantling according to the regulation of the car manufacturer) – Disconnect the battery. – Remove the front bumper – Remove the front fender – Disconnect the cables (cable tree bodywork / door) – Loose the hinge at the A-pillar – Dismantle the door hinges from the door. – Extend the door cable tree with the. ( see enclosure “cable extension” ) (see enclosure “modification of the fender“) Tip/Advise: a second person makes ) Reference:
On the driver’s side additionally the splash-water container must be removed and be installed in another place at the vehicle again. (assembly suggestion on the last sides) Installation LSD-Door Mounting/Hinge: 1.) Dismantle the swing arm off the chassis plate 2.) Mount the LSD chassis plate at the fitting points at the original door hinges at the bodywork. Please use screws (A) and fix it in the middle of the hole. Please exchange additionally the cable plug-in connector with the dummy plug (as shown on picture under point 13) 3.) Screw on the LSD swing arm onto the former original fitting points of the hinge at the already dismantled door. Use the screws (B) and only slightly tighten it. Screws have to be positioned in the long hole in the middle. 4.) Tighten the adjustment screw (3) slightly. 5.) Fix the door to the car, therefore door has to be closed completely. 6.) Fix the swing arm to the chassis plate with allen bolts (4x) and adjust the door via moving the swing arm to chassis plate adjustable connection mount with horizontal door gap adjuster (Gap measurement like original). 7.) Adjust the height of the door by vertical movement of the chassis plate. Therefore please loose the screws (A) at the chassis plate.