download 2005 Toyota Highlander Rear Axle Hub & Bearing Assy Lh (Ff) Replacement. HINT: COMPONENTS: SEE PAGE 30-4 Replace the RH side by the same
procedures with LH side. 1. REMOVE REAR WHEEL 2. SEPARATE RR DISC BRAKE
CALIPER ASSY RH (a) Remove the bolt and separate the flexible hose.
C83014 (b) Remove the 2 bolts and brake caliper. (c) Support the brake
caliper securely. C83008 3. REMOVE REAR DISC (SEE PAGE 32-29 ) 4.
SEPARATE SKID CONTROL SENSOR WIRE (a) Disconnect the connector.
5.
REMOVE REAR AXLE HUB & BEARING ASSY LH (a) Remove the 4 bolts and
axle hub. G32184 G32184 7. INSTALL SKID CONTROL SENSOR WIRE (a) Connect
the connector. 8. INSPECT BEARING BACKLASH (a) Set a dial indicator near
the center of the axle hub and check the backlash in the bearing shaft
direction. Maximum: 0 mm (0 in.) If the backlash exceeds the maximum,
replace the axle hub as- sembly. C83015 9. INSPECT AXLE HUB DEVIATION
(a) Using a dial indicator, check the deviation at the surface of the
axle hub outside the hub bolt. Maximum: 0.08 mm (0.0031 in.) If the
backlash exceeds the maximum, replace the axle hub as- sembly. C83016
10. INSTALL REAR DISC (SEE PAGE 32-29 ) 11. INSTALL RR DISC BRAKE
CALIPER ASSY RH (a) Install the brake caliper with the 2 bolts.