download Special tools, testers and auxiliary items required Jointed wrench 3185
Socket T10058 Torque wrench V.A.G 1331 Hand drill with plastic brush
Protective goggles Flat scraper Silicone sealing compound D 176 404
A2 Locking fluid D 000 600 A2 Removing Remove center and right sound
insulation Engines with oil pan protection Body Exterior – Repair
Group 50. Remove bolts – 2 – and take sleeves – 3 – off front and rear
parts of oil pan protection. Press spreader pin out upward and remove
spreader rivets – 4 – . Remove oil pan protection – 1 – . Engines with
LongLife Service Pull 3-pin connector off Oil level thermal sensor
-G266-. Continuation for all engines Drain engine oil.
Note: Observe
disposal regulations! Remove oil pan bolts. Note: Loosen oil pan
bolts with jointed wrench 3185 and remove with socket T10058. Remove
oil pan. Loosen pan with light blows of a rubber headed hammer if
necessary. Remove sealant residue on cylinder block with a flat
scraper.